Diversey Crew Restroom Disinfectant Cleaner

Non-acid restroom disinfectant cleaner cleans, disinfects and deodorizes in one easy step. Crew Restroom Floor and Surface Non-Acid Disinfectant Cleaner provides broad-spectrum efficacy against common bathroom microorganisms. It kills HIV-1, Staphylococcus aureus, Salmonella choleraesuis, E. coli, MRSA, VRE and other microorganisms. Disinfectant cleaner disinfects in up to 400 ppm hard water and deodorizes as it disinfects. EPA certified formula is recommended for hard, nonporous, washable surfaces in and out of the restroom. Cleaner utilizes Crew fresh scent to keep consistent with most Crew restroom products. It comes in a J-Fill bottle that works with the J-Fill dispensing system for dispensing accurate cleaning solutions with no measuring, mixing or mess. Metering tip in every bottle ensures precise dilution, reduces maintenance and eliminates the possibility of tampering with dilution ratios. Simply push a button or squeeze the trigger.

• Microorganism
• HIV-1 Human Immunodeficiency Virus Type 1
• Staphylococcus Aureus
• Escherichia Coli
• Vancomycin-resistant Enterococci (VRE)
• Methicillin-resistant Staphylococcus Aureus (MRSA)
• Salmonella Enterica

• For use on hard, nonporous inanimate environmental surfaces such as floors, walls, glazed porcelain, glazed ceramic tile, plastic surfaces, shower stalls, bathtubs and cabinets
• To disinfect inanimate, hard nonporous surfaces, dilute according to label directions.
• Apply solution with a mop, cloth, sponge or hand-pump trigger sprayer so as to wet all surfaces thoroughly.
• Allow to remain wet for 10 minutes then remove excess liquid.
• For heavily soiled areas, a pre-cleaning step is required. Prepare a fresh solution for each use.

• Insert cartridge into dispenser (see J-FILL® dispenser instructions for proper cartridge placement). Fill small bottle or bucket or use gun to apply a foam directly onto surfaces to be cleaned, scrubbing with a soft brush, pad or cloth. Do not allow foam to dry. Rinse surfaces thoroughly. NOTE: Some commercial strength cleaners are unsuitable for use on some surfaces. Test in an inconspicuous area prior to use.

• Fill trigger spray bottle with product. Apply to surfaces to be cleaned.
• Wipe with clean cloth or towel to dry. Dilute with cold water.
• To avoid food contamination after cleaning, sanitize and rinse all food contact surfaces with potable water before reuse.

• Deodorize
• No-mess
• Rinse-free